Filter
Top Products
4
TELEPHONE PART IDENTIFICATION
1. Liquid Crystal Display (Multi-Angle LCD) - Displays the phone
number, date and time and other information.
2. One-Touch Memories - Phone numbers can be stored for speed
dialing.
3. Del/Set - Press and Hold for 3 seconds to bring up menu. Press to
enter and confirm settings. Press to delete or edit the telephone
number when reviewing caller IDs.
4. Call Back - When reviewing Caller ID records, press to dial the
saved number.
5. - Press to enter the phone book.
6. VIP - Press to enter, set or remove VIP numbers.
7. Store - Press to store the one-touch speed dial memories.
8. AUTO RD (Auto Redial/Change Ring Tone)
a. Press to auto redial the last dialed number
continuously until the phone is answered.
b. Press and hold for 3 seconds to change ring tone.
9. Redial/Pause - Press to redial and review the last dialed numbers.
10. Hold - Press to place the line on hold.
13
TELEPHONE SERVICE PROBLEMS
If you have any problems with your telephone equipment
service, determine if the problem is with your unit or the telephone
company lines. BEFORE CALLING THE TELEPHONE COMPANY. Be aware
that they may charge you for a service call if the problem is caused by
your telephone equipment.
TROUBLESHOOTING
PHONE DOES NOT RING
• Line cord is disconnected at telephone outlet or at telephone
end.
• Phone is OFF HOOK. Make certain the hookswitch is depressed
when the handset is in the cradle.
• SPEAKERPHONE is on. Turn off speakerphone.
NO DIAL TONE
• Wire is disconnected at telephone jack or at wall jack. Test the
telephone in a different wall jack. If it works, the first jack may
be defective.
HAVE DIAL TONE BUT CANNOT DIAL OUT
• Incorrect dialing mode. Switch to DTMF or PULSE mode as
needed.
BLANK SCREEN
• Since this unit is line powered, the screen is blank while not on
a call.
CALLERS ARE NOT DISPLAYED ON THE SCREEN
• Verify that you have subscribed to the appropriate service
(Caller ID and Call Waiting Caller ID) from your telephone
company. If you only subscribed to Caller ID service this unit
will not display the call waiting caller ID information.
• Check if your answering machine is set to answer the call before
2 rings.
Always disconnect all the telephone cords, and then reinstall the unit
step by step per this instruction manual before asking for service.