Filter
Top Products
© 2001 Firstech, Inc. Page 7
Safety Shut Down Features
CompuStar system has several shut down safety features. The following actions will shut down the engine or prevent the vehicle from auto-starting:
Opening of the car engine hood, Pressing of the brake or Valet mode is turned on.
OPTIONAL PROGRAMMABLE FEATURES
These additional programmable features can be programmed to the CompuStar system by your authorized CompuStar dealer.
Ignition Lock
Automatic Transmission Vehicle: This programmable option enables your vehicle to automatically lock the doors upon starting the vehicle with a key.
In addition, the vehicle will automatically unlock the doors upon pulling the key out from the ignition. This option must be chosen at the time of
installation.
Manual Transmission Vehicle or Turbo Mode: This programmable option will locks the doors in 5 seconds after starting the vehicle with a key and
the emergency brake is released.
Passive Locking
You can turn this function on or off by pressing Buttons (II+III) for a ½ second.
1. When set to passive locking, your doors will lock automatically 30 seconds after all the vehicle doors are closed.
Turbo Mode
If this optional Turbo Mode has been programmed at the time of installation, you can turn this feature on and off by pressing Buttons (III+IV) for
a ½ second.
Under this mode, the engine continues running for 2 minutes after key has been taken out from the ignition if emergency brake was on when the key
is taken out. To utilize this mode, the emergency brake sensing wire has to be connected to the emergency brake wire of the vehicle. Consult the
authorized dealer for this mode.
OPTIONAL INSTALLATION FEATURES
The CompuStar 2WFMR(S) remote has additional features and expansion possibilities that require additional parts and labor.
Cold Start Mode
If the optional temperature sensor has been installed, Timer Start Mode becomes Cold Start Mode. Under this mode, your vehicle will
automatically start if the temperature of the inside of the vehicle goes below the preset temperature. The minimum interval between the starts will be
1.5 or 3.0 hours depending on preset options during the time of installation. Cold Start Mode is activated or deactivated by pressing Buttons (II+IV)
for a ½ second.