Filter
Top Products
© 2001 Firstech, Inc. Page 3
Safety Information
Please take these safety precautions into consideration, under the following conditions:
1. Servicing the vehicle
When servicing your vehicle (i.e. changing the oil, tire rotation), the CompuStar system should be in Valet Mode. There is a safety shutdown switch
under the hood that deactivates the remote starter function if the hood is open. However, if the switch has been damaged or the switch has been
installed improperly, the vehicle may start when Button II is pressed for 2 seconds even if the hood is open.
2. Loaning your vehicle to others
Whenever you loan your vehicle to an individual who is not familiar with Compustar, please put the vehicle in Valet mode. This will prevent the
vehicle loaner from accidentally activating the CompuStar remote start system.
3. For manual transmission vehicles
If the Compustar 2WFMR(S) is installed in a manual transmission vehicle, extra precautions are required because the Compustar does not monitor
the gear shift:
Important! Under normal circumstances, Reservation Mode is cancelled when a door or hatchback opens. Please verify if the opening of any door
or hatchback cancels Reservation Mode. If any of the doors or hatchback is not being monitored by the CompuStar because of improper installation
or a faulty dome light switch. Do not operate the CompuStar system, and take your vehicle to the dealer immediately for repair.
Do not set Reservation Mode when the window(s) are open or if there is anyone inside of the vehicle including animals.
Firstech, Inc. will not be responsible for any damages resulting from improper installation or a faulty dome light switch.
Important Requirements to activate Reservation Mode
CompuStar does not monitor the location of the gear. It is your responsibility to leave the transmission in the neutral position before you remote start.
If the reservation is set when the transmission is in gear or if you move the transmission gear after the reservation has been activated, the vehicle
will move when the engine will start and Firstech will not be responsible for any damages.
Two Way Remote: 2WFMR(S)
The model name, 2WFMR(S), stands for Two Way Frequency Modulation Remote for Starter only. This transmitter will allow you to activate
multiple functions of the Compustar by pressing a combination of 4 buttons on the unit in order to transmit signals.
Two Way Remote Button Functions
The button functions of the 2WFMR are very similar with the 2WFMR (Two Way Remote-Pager with LCD). The difference between 2WFMR(S) and
2WFMR is that the 2WMFR(S) is not a remote pager. If you are using 2WFMR(S) for an alarm/starter combo unit, please consult your dealer for
more button functions.
Note: This remote, 2WFMR(S), will not confirm a zone being violated when used with a Compustar alarm or alarm/starter controller module. (i.e.
Open door or shock sensor
Button Pressed For Function
1. I 1/2 sec Lock/Unlock, Anti-Grind – on/off
2. II- 2 seconds Auto-start on/off
3. III- 2 seconds Trunk Release
4. IV 1/2 sec Query Function
5. (I+III) 1/2 sec Valet Mode – on/off
6. (II+III) 1/2 sec Passive Lock – on/off
7. (II+IV) 1/2 sec Timer Start Mode - on/off
8. (III+IV) 1/2 sec Turbo Mode - on/off
9. (I+III) - 2 sec Shock Sensor – on/off
10. (I+II) - 2 sec Programming Menu 1 – Installer Only
11. (I+IV) - 2 sec Programming Menu 2 – Installer Only