Filter
Top Products
3. Insert GA-3ANH batteries
according to polarity markings.
NOTE: Estimated operation time
on full charge:12 hours.
These rechargeable batteries
must be recycled or disposed of properly in
compliance with all applicable laws. They must
not be thrown in the rubbish bin. Some countries
and local authorities require recycling and have
established collection programs. Please contact
your local waste disposal authority for instructions.
WARNING: Do not put batteries into fire or expose
to high heat. They may explode.
For Charging Cobra’s microTALK
®
Radio(s):
1. Insert radio(s) into the
charger as shown.
2. Insert round connector of
230 volt adaptor into jack
on back of charger.
3. Plug 230 volt adaptor into
mains socket.
If charging light is not On, check position of radio.
Radio should be upright.
The charge indicator light will stay On as long as
the radio is in the charging well, even after the
batteries are fully charged.
It normally takes about 15 hours to fully recharge
batteries. Batteries will not be damaged if they
stay in the charging well longer than that.
Insert Radio(s)
OPERATION
Product Information
T
his microTALK
®
r
adio has been manufactured to
meet all required standards for radio equipment
using PMR 446 frequencies as authorized. The
use of this two-way radio product involves the
public airways and its use may be subject to local
l
aws or regulations. Contact your radio licensing
authority for more information.
Caring for Your Radio
Your microTALK
®
radio will give you years of
trouble-free service if cared for properly. Here are
a few suggestions:
• Handle the radio gently.
• Keep it away from dust.
• Never put the radio in water or in a damp place.
• Avoid exposure to extreme temperatures.
Desktop Charger and
Rechargeable Batteries
To Insert Batteries in
Radio:
1. Remove belt clip by
releasing belt clip latch and
sliding clip up.
2. Pull down on lock tab to
remove battery cover (on
back of radio).
English
Each port can charge one radio. Uses 230 volt
a
daptor. Use only Cobra NiMH batteries, model
GA-3ANH with charger model PA-CD3.
C
obra recommends your radio is turned Off while
being charged.
Radio Power
To Turn Your Radio On:
–
Press and hold the POWER
button until you hear a
series of audible tones
indicating that the radio
is On.
Your microTALK
®
radio is now in LISTENING MODE,
ready to receive transmissions. The radio is always
in LISTENING MODE, except when the TALK, CALL
or MODE buttons are pressed.
To Turn Your Radio Off:
– Press and hold the POWER button.
Battery Low Indicator
When battery power is low,
the BATTERY LOW indicator
will blink, indicating that
batteries should be recharged
or replaced.
WARNING: Only the supplied NiMH batteries
can be recharged.
Battery/Power Saver
If there are no transmissions
within ten (10) seconds, the
unit will automatically switch
to Battery Save Mode and
POWER SAVER will appear in
the display. This will not affect the unit’s ability
to receive incoming transmissions.
Communicating with
Another Person
To Talk To Another Person:
1. Press and hold the TALK
button.
2. With the microphone about
5 cm (2 inches) from your
mouth, speak in a normal
voice.
3. Release the button when
you have finished talking
and listen for a response.
You cannot receive incoming
calls while pressing the T
ALK button.
NOTE: Both radios must be tuned to the same
channel and privacy code to communicate.
Remove Belt Clip
Power Button
Lock Tab
Insert Batteries
5 cm (2 Inches)
From Mouth
Talk Button
Battery Low
Power Saver