Filter
Top Products
65
Nothing Comes Close to a Cobra
®
Advanced Operation
64
English
Introduction
Advanced Operation
Tri-Watch Mode
Tri-Watch mode gives you one (1) button access to scan a
total of three (3) channels of most importance to you.
Channel 16 is preprogrammed for you and will always be
one (1) of the scanned locations. Two (2) other channels of
your choice can be stored in the radio. These channels can
be edited and/or recalled for future engagements of the Tri-
Watch mode. Tri-Watch will function in Marine and GMRS
Standby modes.
NOTE
The radio must be squelched for Tri-Watch mode to
function. See page 40 for Squelch procedure.
To Program or Edit the Tri-Watch Locations:
1. Press and hold the TRI-WATCH button for two (2)
seconds to activate Tri-Watch Setup mode. The TRI
and MEM icons on the display will turn On.
NOTE
The main channel number will flash to indicate channel
position. If there is no input activity for 15 seconds, the
radio will sound two (2) beeps and return to Marine or
GMRS Standby mode.
2. Press BAND button to select Marine or GMRS for
the first Tri-Watch programmable channel.
3. Press Channel Up/Down button to select the desired
Tri-Watch channel.
4. Press and release TRI-WATCH button or
Call/Enter/Setup button to confirm entry.
5. Repeat steps 2 through 4 to select second
Tri-Watch programmable channel. The radio will
scan Marine Channel 16 plus two (2) other selected
channels in Marine or GMRS bands.
6. After programming both Tri-Watch memory
channels the radio will immediately engage
Tri-Watch mode.
OperatingYour Radio
Using Tri-Watch
Tri-Watch Scan Mode:
1. From Marine or GMRS Standby mode, press the
TRI-WATCH button. The TRI icon will appear on the
LCD display and the radio will scan through the
three (3) Tri-Watch memory channels.
2. A signal on any one (1) of the three (3) channels
will stop the scan for 10 seconds to allow you to
listen to the traffic on that location.
NOTE
After the Tri-Watch scan stops to monitor a channel,
as long as you do not press any buttons within 10
seconds, your radio will automatically resume
scanning the Tri-Watch channels.
3. Press the Channel Up/Down button to resume
scanning the Tri-Watch channels or to change the
scan direction.
4. To EXIT the Tri-Watch scan, press the TRI-WATCH
button again. The TRI icon will disappear from the
LCD and the radio will return to Marine or GMRS
Standby mode.
OperatingYour Radio
TRI-WATCH Button
TRI and MEM Icons
Channel Up/Down Button
T
RI-WATCH Button
Tri-Watch Scan Mode