Filter
Top Products
Introduction
45
Nothing Comes Close to a Cobra
®
44
English
Introduction
Setup Mode Programming Setup Mode Programming
Setup Mode Programming
•
The following series of procedures is designed to allow you to set the programmable
features of your radio. Correctly following these steps results in a minimal amount
of radio setup programming time.
NOTE
When in any of the Setup modes (Marine (VHF), GMRS or WX Alert), if you
stop programming for longer than 15 seconds, your entry will be saved and
the radio will go back to the specific Standby mode that you were in when you
started programming. When you return to Setup mode and continue
programming you will see the last “value” displayed. While in any Setup mode,
you will not receive any signal reception.
Programming these features will allow you to customize certain features of this
radio to enhance your “On-Water” audio needs.
Start from Marine Standby mode to begin Marine (VHF) Setup programming. Press
and hold the Call/Enter/Setup button for two (2) seconds to enter the programming
mode.
Marine (VHF) Mode Programming
USA/International/Canada Channel Maps
Three (3) sets of VHF Channel Maps have been established
for marine use in the USA, Canada and the rest of the world
(International). Most of the channels are the same for all
three (3) maps, but there are definite differences (see table
on pages 20 through 27). Your radio has all three (3) maps
built into it and will operate correctly in whichever area you
choose.
To Set Channel Map Operating Area:
1. The Channel Map mode is the first mode that
begins the Marine (VHF) Setup programming.
2. U, I and C icons will display, with the current setting
(the U icon is the default) flashing.
3. Press Channel Up/Down button to select the U, I or
C icon.
4. Press Call/Enter/Setup button to save this entry and
move to the next setup programming mode.
NOTE
One or two of the channel maps might have been
disabled for sales of this radio in some countries.
OperatingYour Radio OperatingYour Radio
S
et Channel Map
Channel Up/Down Button
Active Channel Map Icon