Filter
Top Products
23
Mode Functions
22
VibrAlert and Call Alert
•
Your microTALK radio can alert you to incoming signals by sounding an
audible call tone, by vibrating silently or both.
To change call settings:
1. Press the Mode button
until the Call Setting icon
flashes on the display.
The current setting (“01”
vibrate + ring, “02” vibrate
only or “03” ring only)
is displayed.
2. Press the Channel Up or
Channel Down button to
change the call setting.
3. Choose one of the following:
a. Press the Mode button to enter the new setting
and proceed to other functions.
b. Press the Lock/Enter button to enter the new setting and return to
Standby mode.
During memory location scan (while receiving an Incoming trans-
mission), you can choose from the following:
a. Press and hold the Talk button to communicate on that
memory location.
b. Your radio will remain on that memory location and return to
Standby mode. Press the Channel Up or Channel Down button to
resume scanning memory locations.
c. After 10 seconds of inactivity, unit starts scan again.
If you press the Talk button while scanning, but more than 10 seconds
after receiving a transmission, you will transmit on the memory location
on which, during scanning, you last received a transmission.
If you do not press any button within 10 seconds, your radio will
automatically resume scanning memory locations.
During memory location scan (while not receiving a transmission),
you can choose from the following:
a. Press and hold the Talk button to communicate on the
channel/privacy code that was displayed before you entered mode
functions or memory location on which, during scanning, you last
received a transmission.
b. Press the Mode button to proceed to other functions.
c. Press the Lock/Enter button to return to Standby mode on the
channel/privacy code that was displayed before you entered mode
functions or the memory location on which, during scanning, you
last received a transmission.
To reduce the number of memory locations being scanned, you may
de-program any unwanted locations. (See page 16 to de-program a
memory location.)
Operation Customer Assistance WarrantyIntroduction Operation
Mode Button
Channel Buttons
VibrAlert + Ring
VibrAlert Only
Ring Only
Nothing Comes Close to a Cobra
®