Filter
Top Products
19 – ENGLISH
hearing aid “T-switch” to the “T” position. Make sure to hold
the handset close to your T-coil.
█
Using your Speakerphone
For optimal speakerphone performance, avoid the following:
• Areas with high background noise (The microphone
might pick up these sounds and prevent the
speakerphone from going into the receiving mode
when you finish talking).
• Surfaces affected by vibration.
• Recessed areas such as in a corner, under a cupboard,
or next to a cabinet, which can generate an echo effect.
To answer or place a call using the speakerphone, press the
Speaker key on the base.
█ Answering a Call
NOTE: Make sure the ringer switch is set to HI, MED or LO, or
the phone will not ring. If you have selected the strobe to be
ON, it will flash on all settings.
Using the Handset
1. To answer a call, lift the handset and speak.
2. Adjust your volume and tone settings if needed.
3. To end the call, replace the handset on the base.
Using the Speakerphone
1. To answer a call, press the Speaker key on the base.
2. Adjust your volume by using the volume control
VOLUME- or VOLUME+ located on right side of the
phone.
3. To end the call, press the Speaker key again on the
base.
Using a Headset or Neckloop (see page 21)