Filter
Top Products
12 – ENGLISH
To install:
1. Make sure the AC adapter and phone line cord are
disconnected.
2. Open the battery compartment door located on the
underside of the phone by unscrewing the battery
compartment door and removing it from the phone
(screwdriver provided).
3. Correctly insert 4 AAA Alkaline batteries (purchased
separately) in the battery compartment. Be sure to
observe battery polarity as imprinted.
4. Replace the battery compartment door and screw it
back in place.
Desk / Table Mounting
1. Connect one end of the 6 ft phone
cord to the line jack on the back of
the base and connect the other end
to a modular phone jack.
2. Plug the AC power adapter into the
jack on the back of the base, then plug the AC adapter
into a standard electrical outlet or surge protector.
NOTE: The adapter is required for the phone to work.
Wall Mounting
1. Slide the handset hanger tab
out and reverse its position
(rotate it 180 degrees). Slide
it back into place so that the
hook points up (see Diagram 6).
This will keep the handset
from falling out of the cradle
when it is mounted on the wall.
2. Plug the AC power adapter into
the jack on the back of the telephone. Wait until the
phone is completely setup before plugging the AC
adapter into the electrical outlet or surge protector.
NOTE: The adapter is required for the telephone to
work correctly.
rear of base
Desk tab
position
Wall mount
tab position
Diagram 6