Filter
Top Products
19 – ENGLISH
against such interference in a residential installation. However, there is no
guarantee that interference will not occur in a particular installation. If your
product causes interference to radio or television reception when it is in use,
you might correct the interference with any one or all of these measures: (a)
where it can be done safely, reorient the receiving television or radio antenna.
(b) To the extent possible, relocate the television, radio or other receiver with
respect to the telephone equipment. (c) If your telephone product runs on AC
power, plug your product into an AC outlet that is not on the same circuit as the
one used by your radio or television.
INDUSTRY CANADA CS03 STATEMENT
This product meets the applicable Industry Canada technical specifications.
This is confirmed by the registration number. The abbreviation, IC before the
registration number signifies that registration was performed based on a
Declaration of Conformity indicating that Industry Canada technical specifications
were met. It does not imply that Industry Canada approved the equipment.
Before installing this equipment, users should ensure that it is permissible
to be connected to the facilities of the local telecommunications company.
The equipment must also be installed using an acceptable method of
connections. The customer should be aware that compliance with the above
conditions may not prevent degradation of service in some situations.
Repairs to certified equipment should be made by an authorized Canadian
maintenance facility designated by the supplier. Any repairs or alterations
made by the user of this equipment, or equipment malfunctions, may give
the telecommunications company cause to request the user to disconnect
the equipment.
WARNING! Users should not attempt to make such connections themselves,
but should contact the appropriate electric inspection authority, or an
electrician, as appropriate.
CAUTION: The Ringer Equivalence Number (REN) assigned to each terminal
device provides an indication of the maximum number of terminals allowed
to be connected to a telephone interface.
The termination on an interface may consist of any combination of devices
subject only to the requirement that the sum of the Ringer Equivalence
Numbers of all the devices does not exceed 5. An alternative indication of
the REN is the Load Number (LN); this number should be divided by 20 to
approximate the equivalent REN. The REN Number of this unit is indicated
on the bottom of your answering machine.
If your home has specially wired alarm equipment connected to the
telephone line, ensure the installation of TALK500 does not disable your
alarm equipment. If you have questions about what will disable alarm
equipment, consult your telephone company or a qualified installer.