Filter
Top Products
W-1000Page 14
Operating the Walker Clarity®
Once you have installed your Walker
Clarity according to the instructions
noted previously, it will be ready to use.
To Place or Receive
a Call:
Note: If you made an
error while dialing, just
depress the hookswitch,
listen for a dial tone,
and dial again.
3. When placing a call, dial as you would
any phone and wait for someone to
answer.
4. Adjust the Clarity Power Control
upwards to a level where the other
party’s voice is heard loud and clear, and
begin conversation.
5. When you complete the call, return
the handset to the base unit and slide
the Clarity Power Control back down
to its lowest setting (this will let other
users adjust the Clarity Power Control
to their level).
The light will flicker when the person
on the other end of the phone is talking.
1. Adjust the Clarity Control to its
lowest setting (zero).
2. Pick up the handset and listen for the
caller’s voice or a dial tone. Watch the
green sound level light located on the
phone base, next to the program
button. It will be bright and steady when
a dial tone is present. It will flash in
rhythm with a busy signal.
E
N
G
L
I
S
H
W1000_User_Guide 11/15/99, 9:38 PM14