Clarity RC200 Conference Phone User Manual


 
CHAPTER 7
(CONTINUED)
CHANNEL SETTINGS
The RC and Remote Transmitter use radio
signals to communicate with each other. For
the Remote Transmitter to activate the
RC,
they both have to be on the same "channel."
A "DIP Switch" is used for channel selection.
Your phone and remote have been preset at
the factory to a standard channel setting.
Under normal operating conditions, there is
no adjustment necessary.
If your system encounters interference and
repeatedly activates by itself for no obvious
reasons, it may be necessary to change DIP
Switch settings on the
RC and Remote
Transmitter.
1. Unscrew bottom of the Remote
Transmitter.
2. Locate DIP Switches on Remote
Transmitter and on bottom of
RC.
3. Using a ball point pen, change the
settings on all switch positions to
match exactly on both RC
and Remote Transmitter.
4. Replace remote cover and test.
Figure 24 – Channel setup
ON
1 2 3 4 5 6 7 8
ON
1 2 3 4 5 6 7 8
S
E
T
T
O
M
A
T
C
H
E
X
A
C
T
L
Y
13
(Remove cover to
expose switch)