Filter
Top Products
40 41
REGISTER/DEREGISTER HANDSETS
Your telephone can support up to ve cordless handsets. The additional
handset(s) needs to register with the telephone base before use. You must
register each additional handset separately.
The handsets provided within your product box are already registered as
HANDSET 1 and so forth. Additional handsets are assigned numbers in the
order they are registered (HANDSET 2 to HANDSET 5).
When rst purchased, all expansion handsets alternately display
• Press FIND on base 4 sec
and
• Then press # on handset.
The new handset should be charged without interruption for at least 30
minutes before registering to the telephone base.
Register a handset
1. In idle mode, press <MENU/SELECT>, then <UP/DOWN> to select
Registration.
2. Press <MENU/SELECT> and screen will alternately show
• Press FIND on base 4 sec
and
• Then press # on handset
3. Press and hold <FIND> on the telephone base for about four seconds,
until the SPEAKER light turns on; release the <FIND> key.
4. Press # (pound key) on the handset. The screen shows Registering...
Please wait.
When the handset is registered successfully, HANDSET registered
and then HANDSET X appears on the screen, with X being the handset
number (1-5).
If the registration is not successful, the handset screen shows Registration
failed. Please start again from step 3 above.
Note: You cannot register a handset if any other system handset is in use. To
register an expansion handset, follow from the step C as above.
Deregister all handsets
You can deregister handsets. You may need to deregister your handsets if:
You have ve registered handsets and need to replace a handset.
-OR-
You wish to change the designated handset number of your registered
handsets.
You must rst deregister ALL the handsets, and then register each handset you
wish to use again, one at a time.
1. Press and hold <FIND> on the telephone base for about 10 seconds,
until the SPEAKER light starts ashing; release <FIND>.
2. Immediately press <FIND> again; you will hear two quick beep
tones.
3. When complete, the handset screen alternately shows
• Press FIND on base 4 sec
and
• Then press # on handset.
4. To register the handset(s) to the telephone base again, follow the
registration instructions in section Register a handset.
Note:
• If the deregistration process is not successful, you might need to
reset the system and try again. To reset, unplug the power from the
telephone base and plug it back in.
REGISTER/DEREGISTER HANDSETS