Filter
Top Products
CLARITY W1000
18
PROGRAMMING
4. Dial the number you wish to store. The
number is not transmitted while you are
programming it.
5. Press the “PROGRAM” button again.
6. Select the appropriate memory storage
button. Press and release this button.
7. Place handset back into cradle.
8. Repeat steps 3 through 7 for all other
memory storage locations.
➤
To Dial
Programmed Numbers:
1. Pick up the handset and listen for a
dial tone.
2. Press the appropriate Memory
Storage Button.
3. The number will be dialed automatically.
➤
To Delete
Programmed Numbers
1. Pick up handset.
2. Press and release the program button.
3. Press either the # key or 0 either 7 or 11
times (Once for each digit you are trying
to delete).
4. Press and Release the program
button again.
5. Press the memory location button you
are wanting to delete the number from.
6. Return the receiver to the cradle.
➤
Change A Stored Number
Replace a stored number by programming
a new number its place.
Important: The HELP BUTTON is not
pre-programmed for 911. Once program-
ming is completed select the appropriate
sticker from the sticker set provided and
place on the red button.
Programming Note: During the program-
ming sequence the dial tone MAY NOT
break and in some instances an operator
intercept may come on the line. This is
normal. Continue with the programming
sequence to completion.
Note: You can program a pause into the
dialing sequence if necessary. Since there
is not a pause button on the telephone, the
redial button serves this purpose during
programming. Programming in a pause
will cause the phone to wait 3 seconds
before dialing any more numbers. For
Example: Pressing a memory button that
has 9 (pause) 555-1212 programmed into
it will dial the number 9, then wait 3 sec-
onds and dial 555-1212. In most cases,
you will not need to use a pause. You can
store up to 16 digits and the pause func-
tion counts as 1 of those digits.