Filter
Top Products
38
English
FZ709E
OFF
This unit continues normal operation even
when the accessory is interrupted.
Common Operations
Setting the dimmer control
You can set the dimmer control “ON” or “OFF”.
∗
The factory default setting is “ON”.
3 - 1 .
Select “DIMMER”.
3 - 2 .
Touch
[ ]
key to enter detail setting stage.
3 - 3 .
Slide along
[
]
slider or touch
[
]
/
[
]
key to select “ON” or “OFF”.
Anti-theft indicator
The red Anti-theft indicator is a function for pre-
venting theft.
∗
The factory default setting is “OFF”.
3 - 1 .
Select “BLINKING LED”.
3 - 2 .
Touch
[ ]
key to enter detail setting stage.
3 - 3 .
Slide along
[
]
slider or touch
[
]
/
[
]
key to select “ON” or “OFF”.
AUX function
This system has an external input jack on the
rear panel so you can listen to sounds and music
from external devices connected to this unit.
Performing a system check
This function allows you to perform a system
check from the adjust mode when required.
3 - 1 .
Select “SYSTEM CHECK”.
3 - 2 .
Touch
[
ENT
]
key. “SYSTEM CHECK” ap
-
pears in the display.
3 - 3 .
After finish checking, this unit will switch to
previous mode.
OFF
Use for inside AMP.
ON
Use with connected AMP.
Setting the external amplifier
When an external amplifier is used, the noise can
be decreased by turning off the power supply of
the internal amplifier.
∗
The factory default setting is “OFF”.
3 - 1 .
Select “AMP CANCEL”.
3 - 2 .
Touch
[ ]
key to enter detail setting stage.
3 - 3 .
Slide along
[
]
slider or touch
[
]
/
[
]
key to select “ON” or “OFF”.
Selecting AUX IN sensitivity
Make the following settings to select the sensi-
tivity when sounds from external devices con-
nected to this unit are difficult to hear even after
adjusting the volume.
∗
The factory default setting is “MID”.
1. During AUX mode, touch the
[
]
key to switch
to ADJ menu.
2. Select OPTION in the menu to enter AUX OP
-
TION mode.
3. Select “AUX SENSE” and touch
[
]
key to
enter detail setting stage.
4. Slide along
[
]
slider or touch
[
]
/
[
]
key
to select “HIGH”, “MID” or “LOW”.
Note:
When AUX mode is selected, AUX IN sensitivity
can be set.
Accessory interrupt setting
If you connect this unit and supported accessory
with a separately sold cable, you can listen the
output sound on your car speakers.
∗
The factory default setting is “OFF”.
3 - 1 .
Select “INT-SWITCH”.
3 - 2 .
Touch
[ ]
key to enter detail setting stage.
3 - 3 .
Slide along
[
]
slider or touch
[
]
/
[
]
key to select “ON”, “OFF” or “MUTE”.
ON
You can listen from the speakers when
accessory is connected to this unit.
∗
When listening to the connected accessory,
you can adjust the volume by turning the
[
ROTARY
]
knob.
MUTE
The sound from this unit is muted during
accessory is interrupted.