Filter
Top Products
2-15
Cisco Unified IP Phone Administration Guide for Cisco Unified CallManager 5.0 (SCCP), Cisco Unified IP Phones
OL-8148-01
Chapter 2 Preparing to Install the Cisco Unified IP Phone on Your Network
Adding Phones to the Cisco Unified CallManager Database
After you have collected MAC addresses, in Cisco Unified CallManager
Administration, choose Device > Phone and click Add New to begin.
For complete instructions and conceptual information about Cisco Unified
CallManager, refer to Cisco Unified CallManager Administration Guide and to
Cisco Unified CallManager System Guide.
Related Topics
• Adding Phones with Auto-Registration, page 2-12
• Adding Phones with Auto-Registration and TAPS, page 2-13
• Adding Phones with BAT, page 2-15
Adding Phones with BAT
The Cisco Bulk Administration Tool (BAT) is a plug-in application for
Cisco Unified CallManager that enables you to perform batch operations,
including registration, on multiple phones.
Before you can add phones using BAT only (not in conjunction with TAPS), you
must obtain the MAC address for each phone.
For information about determining a MAC address, see the “Determining the
MAC Address of a Cisco Unified IP Phone” section on page 2-18.
For detailed instructions about using BAT, refer to Cisco Unified CallManager
Administration Guide and to Cisco Unified CallManager Bulk Administration
Guide.
Related Topics
• Adding Phones with Auto-Registration, page 2-12
• Adding Phones with Auto-Registration and TAPS, page 2-13
• Adding Phones with Cisco Unified CallManager Administration, page 2-14