Filter
Top Products
Cisco Unified IP Phone 7970 Series for Cisco Unified Communications Manager 7.0 5
Removing the Hookswitch Clip (Required)
Before you use your phone, remove the hookswitch clip from the cradle area. With the clip removed,
the hookswitch lifts slightly when you pick up the handset.
Adjusting the Handset Rest (Optional)
Cisco recommends adjusting the handset rest, particularly when wall-mounting the phones, as this will
ensure that the receiver will not readily slip out of the cradle. See the table below for instructions.
Adjusting the Footstand (Optional)
To change the angle of the phone base, adjust the footstand while pressing the footstand button.
1
Set the handset aside and pull the square plastic tab from the handset rest.
2
Rotate the tab 180 degrees.
3
Slide the tab back into the handset rest. An extension protrudes from the top of the rotated tab.
Return the handset to the handset rest.
185165
1 2 3