Filter
Top Products
4 WWW.TALKSWITCH.COM
TS-600 USER GUIDE
Connecting power directly from the AC adapter
Alternatively, you can power this phone by directly connecting the AC power
adapter to the phone.
1. Remove the rubber cap covering the DC12V plug behind the phone. It is
located beside the TEL LINE jack.
2. Connect the AC adapter plug to the DC 12V jack of the telephone.
3. After installation, lift the telephone’s handset and listen for the dial tone.
If there is no dial tone, check to make sure all cords are firmly plugged into
their jacks.
WALL MOUNTING
1. Turn the phone over so that you are looking at the bottom of the phone. Insert
tabs at the narrow end of the wall-mount bracket into the holes at the rear of
the phone bottom. Press and latch the tabs at the thicker end of the wall
bracket into holes at the front end of phone. The bracket has two round plastic
holes that can be used to hang your phone on the wallplate on your wall.
Note: If you do not wish to mount your phone on the wall, the Wall Mount
Bracket can be reversed to raise the angle of the phone’s display when sitting
on a table or desk.