Filter
Top Products
BT On-Air 2000 Classic ~ 1st Edition ~ Issue 2 ~ 11th November ’02 ~ 5051
5
Empty
1
/
3
2
/
3
Full
Slide off the battery cover and install the battery.
Replace the battery cover.
2 Install the battery in the handset and
charge them for at least 16 hours
WARNING
Under no circumstances should non-rechargeable
batteries be used. Only use the approved batteries.
Using unapproved batteries will invalidate your
guarantee and may damage the telephone.
Under ideal conditions the battery should give
about 10 hours talktime and 120 hours standby
when the batteries have been fully charged.
WARNING (cont)
Fully discharging the batteries at least once a week
will help them to last as long as possible. However,
the charge capacity of rechargeable batteries will
reduce with time as they wear out, so reducing the
talk/standby time of the handset. Eventually
they will need to be replaced. New batteries can
be obtained from the Helpline on 0870 240 4682.
Please note that your handset must be registered to
the base before use.
Situate your product close enough to the mains
power sockets so that the cables will reach.
Make sure it is at least 1 metre away from other
electrical products to avoid interference.
Do not situate the product in the bathroom or other
humid areas.
Setting up
1 Plug the power adaptor into the wall
socket and switch on
Battery low warning
If the handset battery symbol is empty and you hear
warning beeps, you will need to recharge your
handset before you can use it.
When the battery has been charged for at least 16
hours the display will show the symbol; you can
then connect the telephone line cord to the base.
Plan the location