Filter
Top Products
BT On-Air 2000 Classic ~ 1st Edition ~ Issue 2 ~ 11th November ’02 ~ 5051
18
Generally this telephone may be connected to
switchboards which support tone signalling and
timed break recall. In the event of any difficulties
please consult your switchboard service provider.
When you connect your telephone to a switchboard,
you can set the switchboard’s external line access
code so that when you make an external call using
the handset directory, redial list or preparatory
dialling the code is automatically dialled before the
number.
A total REN of 4 is allowed per telephone line. (For
example: if the BT On-Air Classic is used in
conjunction with three extension telephones, each
with a REN of 1, then the total REN = 4)
Only use approved power supply item code: 872101.
Only use approved batteries supply item code:
872102.
RTTE
This apparatus was designed in compliance with
European Council decision Number 98/482/EC
relative to pan-European connection in view to its
connection on the Public Switched Telephone
Network (PSTN). It is in conformity with Standards
TBR21, TBR38(*)ETSI 201 121.
(*) Terminals integrating an analogue handset function.
If problems arise, your supplier should be contacted
first.
The EC marking attests product conformity with the
essential requirements in compliance with Directives
73/23/EC for User Safety, 89/336/EC for
Electromagnetic perturbations and 98/13/EC for
Telecommunication network access.
The manufacturer declares that the products have
been manufactured in conformity with Annex III of
RTTE Directive 99/05/EC.
Please note this product does not support earth recall.
Switchboard compatibility
Recall
Switchboard External Line
Access Code
This is of use when connected to some
switchboards i.e. to transfer calls or for
some BT Select Services or those services
available via your Network Provider. It is
only available when a call is in progress.
When you need to use recall during a call:-
Press the RECALL button.
appears on the display.
To activate Recall
Recall
Press the UP or DOWN button until the
display shows BASE.
Press the OK button.
Press the UP or DOWN button until the
display shows PARAM.
Press the OK button.
The display will show F.
Press the 2 button twice.
Use the UP or DOWN button to select
either 1 for tone or 2 for pulse (the default
setting is tone).
Press the OK button to confirm.
Press the C button to exit.
To switch between tone and pulse
dialling
▲
▼
COK
▲
▼
COK
2
A
B
C
▲
▼
COK
COK