Filter
Top Products
2. Plug the other end into the mains power wall socket.
Connect the telephone line
1. Plug the telephone line cord into the telephone wall socket.
Setting the time
1. Press . Display shows WHERE?. Now press
(located between the and memory buttons). The
display briefly shows SETUP MODE then HOLD STORE TO
EXIT before moving to the first option RINGER TONE.
2. Press repeatedly until the display shows 12:00AM or
the currently set time.
3. Use the keypad to enter the time, e.g. 0907 = 9:07.
The clock is 12 hour format.
4. Use the buttons to select AM or PM, then press
to save the settings and return to standby.
Getting started 7
BT Relate 3000 ~ Issue 3 ~ Edition 02 ~ 12.08.04 ~ 6346
If you have subscribed to your
network’s Caller Display service, the
time will be set automatically when
you receive your first call.
Holding the button down will
save any settings changed and exit
the set-up mode.
batteries
UM-30R "AA" SIZE
WARNING
Please disconnect
the telephone line cord
before opening this cover
The voice prompts will not work if
the mains power is not connected
and switched on.
6346 Relate 3000 UG [2] 12/8/04 11:19 am Page 7