Filter
Top Products
© 1999 Bogen Communications, Inc.
All Rights Reserved. Printed in U.S.A.
Repairs to this equipment, other than routine repairs, can be
made only by the manufacturer or its authorized agents.
Notice
Every effort was made to ensure that the information in this
guide was complete and accurate at the time of printing.
However, information is subject to change.
If the equipment causes harm to the telephone network, the
local telephone company may temporarily discontinue your
service and, if possible, notify you in advance. If advance notice
is not practical, you will be notified as soon as possible. You will
be given the opportunity to correct the problem and informed
of your right to file a complaint with the FCC.
FCC Statement (Part 15) - Radio Frequency
Interference
The Multiple Digital Message Unit generates and uses radio
frequency energy and if not installed and used in strict accor-
dance with the manufacturer's instructions, may cause interfer-
ence to radio and television reception. Testing is being con-
ducted for compliance with the limits for a Class B device in
accordance with the specifications in Part 15 of the FCC Rules
and Canadian D.O.C. regulations. This testing is designed to
provide reasonable protection against such interference.
However, there is no quarantees that interference will not
occur in a particular installation. If this equipment does cause
interference to radio or television reception, which can be
determined by turning the Multiple Digital Message Unit off
and on, the user is encouraged to try to correct the interfer-
ence by one or more of the following measures:
The local telephone company may make changes in its facilities,
operations, or procedures that could affect the proper func-
tioning of your equipment. If they do, you will be given ade-
quate notice in writing to allow you an opportunity to main-
tain uninterrupted telephone service.
Important Safety Information
Always follow these basic safety precautions when installing
and using the system:
- Reorient the radio or TV receiving antenna.
- Relocate the Multiple Digital Message Unit with respect to
the radio or TV receiver or vice-versa.
- Plug the Multiple Digital Message Unit unit into a different
outlet so that it and the radio or TV receiver are on different
branch circuits.
1. Read and understand all instructions.
2. Follow all warnings and instructions marked on the products.
3. DO NOT block or cover the ventilation slots and openings.
They prevent the product from overheating. DO NOT place
the product in a separate enclosure or cabinet, unless proper
ventilation is provided.
4. Never spill liquid on the product or drop objects into the
ventilation slots and openings. Doing so may result in serious
damage to the components.
5. Repair or service must be performed by a factory author-
ized repair facility.
6. The product is provided with a CSA approved, 3-wire
ground type plug. This is a safety feature. DO NOT defeat the
safety purpose of the grounding type plug. DO NOT staple or
otherwise attach the AC power supply cord to building sur-
If necessary, the user should consult the dealer or an experi-
enced radio/television technician for additional suggestions. The
user may find the following booklet. "How To Identify and
Resolve Radio-TV Interference Problems," helpful. This booklet
was prepared by the Federal Coommunications Commission
(FCC) and is available from the U.S. Government Printing
Office, Washington, DC 20402. Stock order No. 004-000-
00345-4.
Federal Communications Commission (FCC)
Statement (Part 68)
This equipment is component registered with the Federal
Communications Commission (FCC) in accordance with Part
68 of its rules. In compliance with the rules, be advised of the
following:
faces.
7. DO NOT use the product near water or in a wet or damp
place (such as a wet basement).
8. DO NOT use extension cords. The product must be
installed within 6 feet of a grounded outlet receptacle.
9. DO NOT install telephone wiring during a lightning storm.
10. DO NOT install telephone jacks in a wet location unless
the jack is specifically designed for wet locations.
11. Never touch uninsulated wires or terminals, unless the line
has been disconnected at the paging or controller interface.
12. Use caution when installing or modifying paging or control
lines.
Registered eqipment may not be used with Coin Telephone
Lines. Equipment may be used with Party Lines in areas where
state tariffs permit such connections and when equipment is
adaptable for such service.
Support Information
Paging systems integrated with small phone systems such as
Merlin Legend and Partner are supported by the National
Service Assistance Center (NSAC). The main number for the
NSAC is 800-628-2888. Paging systems integrated with large
switches such as the DEFINITY G3 are supported by the
Technical Service Center (TSC). The main number for the TSC
is 800-242-2121.
This equipment is registered as follows:
Registration Number - F4PCAN-20988-AN-N
Ringer Equivalence -1.6B
If trouble is experienced, the equipment should be disconnect-
ed from the interface to determine if this equipment, or the
telephone line is the trouble source. If the equipment is deter-
mined to be malfunctioning, it should not be reconnected until
repairs are effected.
Domestic and International Approvals
CSA Certified LR55025;NRTL/C Certified: FCC Part 15 and
Part 68.