Filter
Top Products
32
X5 Stereo Bluetooth Headset
14. When I connect Audio Streamer to PC via the Y-cable, I hear mono
sounds from Headset. Why?
When headset and Audio Streamer are first connected, it is always in A2DP
mode. So, if you have accidentally pressed the ON/OFF button of headset,
it will switch to Voice mode. So, if you hear sound in monaural form from
the headset, press the ‘MFB’ of the X5 once to switch to Stereo.
15. Why is the X5 noisy and distorted?
A low battery can be the cause of bad voice quality. Please charge the
headset. Some people like to have their phone ring loudly, but this may
cause distortion when transferred to the X5 speaker. In your phone, set up
a Profile with lower ringing volumes and keypad tones and activate when
using with X5.(check your phone user manual for instructions on setting up
profiles). Also, if the antenna strength from your phone network is weak, it
may cause signal drop outs or disruption.
16. I want to connect the Headset with a Bluetooth phone and at the
same time listen to music from an audio device using the Audio
Streamer. How should I make the connection?
To use the Headset with two devices, you have to pair the Headset with
both devices. First, pair Headset with Audio Streamer and then switch OFF
both devices. Next, pair Headset with Bluetooth phone and make the
connection via Headset or Handsfree profile. Now, you can switch on the
Audio Streamer to establish the connection with Headset. Please note that
you can only realize A2DP connection between Headset and Audio
Streamer because the Headset/Handsfree profile has already been used up
by the Bluetooth phone.
17. While listening to music from an audio device connected to the
Audio Streamer, I received a phone call and answered by pressing
‘MFB’ button. Although music stopped, I realized that when the music
replayed, it was not at the point where it was first stopped.
When a call comes in, the music will be muted, not paused, i.e. it will keep
playing in the background.
18. How can I connect the Audio Streamer with a TV and Hi-Fi Set or
iPod?
You can connect the 3.5mm stereo cable into the Headphone Jack. If it
doesn’t fit the plug, you can use an adapter which is available from any
electronics type store for a few dollars.