Filter
Top Products
21
CAMPUS PAGER
2. Turn the Campus Pager over and locate the system code button, which is
inside the hole labeled SYSTEM CODE. Insert a pointed object such as a
straightened paper clip and press the button (see Figure 5-5). The
TRANSMIT display will show the previous system code for about one
second, then shows ___.
Figure 5-1. The Campus Pager system code button.
3. Enter a three-digit system code. After about one second, the display shows
___, and the system code is stored.
4. If you enter a wrong code, reset it by pressing A/C, CANCEL, or the
system code button. Then repeat Steps 2 and 3 to store the system code
again.
NOTE
If your application requires more than 100 system pagers, you can use
multiple Campus Pager systems. If using more than one Campus Pager,
each system should have a unique system code.