Filter
Top Products
16
CAMPUS PAGER
2. Insert the center-loaded antenna connector into the antenna jack on the
right side of the Campus Pager. Turn the connector clockwise until the
antenna locks in place. For maximum efficiency, extend the antenna to its
full length, orient it vertically, and keep it away from walls. See Figure 4-2.
Figure 4-2. Connecting the antenna to the Campus Pager.
3. Mark the positions for the two supplied mounting screws on the wall. The
positions should be 5-7/8” apart. Drill the two holes, then thread the two
screws into the wall. The screws should extend 1/5”. Do not over-tighten
the screws.
4. Align the keyholes on the back of the brackets with the two screws, then
push in and press down to secure the Campus Pager to the wall. See
Figure 4-3.