Filter
Top Products
2
The following features correspond to the numbers in Figure 1.
Note: Two feature buttons must be administered in the following ways:
• One of the feature buttons must be designated as the
Headset On/Off button;
• The Release feature must be administered on a second feature
button.
Headset Connections with the CALLMASTER V
The headset connection for the CALLMASTER V consists of a headpiece
(shown as 1 in Figure 2 below) which is plugged into an adapter cord (shown
as 2).
Note: Your system manager MUST administer a button on your
set. Use this button to turn your headset on and off. For instructions for
using this feature button, see “Headset On/Off” in the section titled
Call-Handling Features.
FIGURE 2 The Headset Connected to One of the Headset Jacks (shown
as 3) on the CALLMASTER V Telephone
1) Telephone Notepad 8) Volume control button
2) Mute (or ) button 9) Display
3) Speaker (or ) button 10) Softkeys
4) Transfer/Test (or ) button 11) Display control buttons
5) Redial (or ) button 12) Hold (or ) button
6) Conf/Ring (or ) button 13) Call appearance/feature buttons
(See Note immediately below)
7) Dial pad 14) Message light – labeled
Headset On/Off
1
3
2