Filter
Top Products
15
below LWC.
Without a display: Press the button
or
Dial the Leave Word
Calling access code (while off-hook).
[dial tone]
2. Dial the extension.
[confirmation tone]
Message light goes on at the called telephone (if so equipped).
3. Hang up.
To cancel a Leave Word Calling message
Note: You cannot cancel a message left for an AUDIX subscriber.
1. With a display: Press the Menu button and then press the softkey
below CnLWC (while on-hook or off-hook).
Without a display: Press the button (while on-hook or
off-hook)
or
Dial the Leave Word Calling cancel code (while off-hook).
[dial tone]
2. Dial the extension. [confirmation tone]
Note: If reorder tone is heard, the message is not canceled; try again.
If your telephone has a display and the Self-Administration feature has been
activated, you will be able to add (or to remove) feature buttons on your own
telephone using the softkeys and the display control buttons.
To administer any of the available features
1. Press the Menu button and then the softkey below Admin.
Note: The telephone must be idle; that is, there must NOT be any
active or held calls.
2. If necessary, enter your security code at the telephone dial pad.
Note: If you enter an invalid security code,
the telephone beeps and
the display shows Incorrect Security Code and Cont. (for
Continue).
Press the softkey below Cont. to proceed.
When you have entered the security code, press the softkey below
Done.
The display shows the first SELECT FEATURE screen which lists the
first set of four self-administrable features. To see the second set of four
features, press the Next button. To go back one menu screen, press the
Prev button.
3. Press the softkey below the feature you want to place on an available
feature button such as CPkUp (Call Pickup) or SAC (Send All Calls).
Note: If you choose the Automatic Dialing or Group Paging feature,
the display prompts you to add a number such as a telephone
number, extension, or trunk code that will be associated with
this particular button. When you have entered the correct
number, press the softkey below Done.
Note: If you wish to see the full name of any of the features on the
feature menu screens (called LongMode), press the softkey
Self-Administration
LWC
Cancel LWC