Filter
Top Products
Testing the Headset
To test the headset, do the following steps:
1. Connect the headset to the CALLMASTER VI.
2.
Press the Headset On/Off button, and listen for the dial tone. If you
do not hear the dial tone, press a Call Appearance button.
If you still do not hear a dial tone, check that the cord is securely
connected to both the jack and to the headset.
It is recommended that you do not
remove the headset adaptor cord
from the CALLMASTER VI unless it becomes necessary to replace
the cord. Disconnect the headset at the quick disconnect point on the
headset cord, not at the CALLMASTER VI jack.
Designation Strips
You receive the following designation strips with the CALLMASTER VI:
●
The first has English descriptions of three buttons (Headset On/
Off, Mute, and Release) and the Message indicator.
●
The second strip was designed for international applications. It
has no descriptions but has the CALLMASTER VI name and
Lucent logo. You would use it to describe buttons in languages
other than English. You can also use it if you do not want button
descriptions, or if the blue
button is not administered for the
Release function.
●
The third strip is blank for custom applications.
A transparent cover holds the designation strip in position on the
CALLMASTER VI voice terminal.
To insert the designation strip, do the following steps:
1.
Remove the transparent cover by pulling the bottom edge of the
cover toward you.
2. Put the designation strip in place.
3.
Replace the cover by hooking it over the top edge of the
CALLMASTER VI voice terminal and snapping it in place over the
bottom edge.
The transparent cover is attached to the frame of the voice terminal by
tabs on the top and bottom of the cover.
9