Filter
Top Products
Avaya Aura Communication Manager Administration
38 Avaya 1600 Series IP Deskphones Administrator Guide
string, SNMP Source IP addresses, and Craft Access Code (PROCPSWD). Administer these
three parameters using Page 3 of the change system-parameters ip-options form.
Administering Stations
This section refers to Avaya Aura Communication Manager administration on the Switch
Administration Terminal (SAT) or by Avaya Site Administration. Administer the following items
on the Station form, sample screens of which are provided in Figure 3
through Figure 6. Avaya
recommends setting the features covered in this section because they optimize the user
interface.
Release 1.1 supports the functionality introduced on Avaya Aura Communication Manager
Release 5.2 that allows call server administration of the GROUP parameter on a
station-by-station basis. As covered in The GROUP System Value
on page 65, the GROUP
Identifier can be used in conjunction with the 46xxsettings file to allow administration to apply to
specific “groups” of telephones. Before Release 1.1, the Group Identifier had to be administered
locally on each applicable telephone. As of Release 1.1, the Group Identifier can be
administered centrally, and downloaded to each applicable telephone. The GROUP ID
parameter is administered on page 3 of the Change Station Form. Once downloaded, the Group
Identifier takes effect starting with the next telephone boot-up.
Avaya Aura Communication Manager Feature Administration
Feature Administration
On-Hook Dialing Set up Avaya Aura Communication Manager so that the phone
supports on-hook dialing. Use the System Parameters Features
form page 10. Use the command Change
system-parameters features to view the form and make
the change.
Auto Hold Set up Avaya Aura Communication Manager to enable Auto
Hold, so that the phone automatically places an active call on
hold when the user answers or resumes a call on another call
appearance. Use the System Parameters Features form, page 6
.
Coverage Path Administer a coverage path for both phone demonstration and
normal operations. Use the Coverage Path form and give it a
number, for example, Coverage path 1. If Voice Mail is available,
this is also where you administer the hunt group or VDN,
depending on the type of Voice Mail system being used.
Enhanced Conference
Features
Enable enhanced conference display to support the user
experience for conferences. Block Enhanced Conference Display
on the Class of Restriction (COR) form must be set to No. Use
the command Change COR, followed by a number, to view the
form and make the change. a sample of the Class of Restriction
form.