Filter
Top Products
2
IMPORTANT INFORMATION:
Use only the power adapter(s) provided with this product. To obtain a replacement, visit our
website at www.telephones.att.com or call 1 (800) 222-3111. In
Canada, dial 1 (866) 288-4268.
The power adapters are intended to be correctly oriented in a vertical or floor mount
position. The prongs are not designed to hold the plug in place if it is plugged into a ceiling,
under-the-table or cabinet outlet.
1.
2.
Plug the power adapter into an electrical outlet not
controlled by a wall switch.
Telephone base and charger installation
If you subscribe to high-speed Internet service (digital subscriber line - DSL)
through your telephone line, you must install a DSL filter between the
telephone line cord and the telephone wall jack. The filter prevents noise and
caller ID problems caused by DSL interference. Please contact your DSL service
provider for more information about DSL filters.
Follow the steps below to install the telephone.
Telephone base installation
Plug the other end of the
telephone line cord into the
telephone jack on the bottom
of the telephone base.
A DSL filter (not included)
is required if you have DSL
high-speed Internet service.
Telephone line cordRoute the cords
through the guides.
Plug the small end of the
larger power adapter into the
power jack on the bottom of
the telephone base.
Plug the large end of the
larger power adapter into an
electrical outlet not controlled
by a wall switch.
Plug one end of the
telephone line cord into
a telephone wall jack.
Raise the antenna.
Telephone base installation