AT&T EL52301 Cordless Telephone User Manual


 
3
Installation
Install the telephone base and charger as shown below. If you subscribe to high-speed
Internet service (DSL - digital subscriber line) through your telephone line, you must
install a DSL filter on the DSL line. If you want to mount your telephone on a wall, use
the included wall mount bracket and refer to Wall mount installation in the online
user’s manual for details.
Plug the large end
of the charger’s
power adapter into
an electrical outlet
not controlled by a
wall switch.
Ensure the small
end of the charger’s
power adapter is
plugged into the
power jack on
the bottom of the
charger.
IMPORTANT INFORMATION:
Use only the power adapters provided with this
product. To obtain a replacement, visit our website
at www.telephones.att.com or call
1 (800) 222-3111. In Canada, dial
1 (866) 288-4268
.
Electrical outlet not
controlled by a wall
switch
Plug the large end
of the base power
adapter into an
electrical outlet not
controlled by a wall
switch.
Telephone wall jack
Plug one end of the
telephone line cord into
a telephone wall jack.
A DSL filter (not included)
is required if you have DSL
high-speed Internet service.
Plug the small end
of the base power
adapter into the power
jack on the bottom of
the telephone base.
Route the cords
through the slots.
Plug the other end of
the telephone line cord
into the TEL. LINE jack
on the bottom of the
telephone base.
Telephone line cord