AT&T E3813B Cordless Telephone User Manual


 
Appendix
45
CONNECTING...
displays on my
cordless handset
Ensure that the telephone base is powered up.
Place the cordless handset in telephone base for one
minute to allow the cordless handset and telephone
base to resynchronize channels.
Move the cordless handset closer to the telephone
base. You might have moved out of range.
If the cordless handset is in its telephone base and
the charging light does not come on, refer to The
charge light is off in this troubleshooting guide.
• Reset the telephone base. Unplug the unit’s electri-
cal power. Wait for 15 seconds then plug it back in.
Allow up to one minute for the cordless handset and
telephone base to reset.
• Other electronic products can cause interference
with your cordless phone. Try installing your phone
as far away from these types of electronic devices as
possible: wireless routers, radios, radio towers, page
towers, cell phones, intercoms, room monitors, tel-
evisions, personal computers, kitchen appliances and
cordless phones.
The batteries will
not hold a charge
Charge the battery in the cordless handset for at
least 16 hours. For optimum daily performance, return
the cordless handset to its telephone base when not
in use.
• You may need to purchase a new battery, please
refer to the Battery section of this user’s manual.
• Your phone might be malfunctioning. Please refer to
the Limited warranty section of this user’s manual
for further instruction.
• If the cordless handset is in its telephone base and
the charging light does not come on, refer to The
charge light is off in this troubleshooting guide.
Troubleshooting