Filter
Top Products
6
Getting started
Telephone base installation
Telephone line cord
DSL filter
(Optional for DSL users,
see number four in the
note section, below.)
NOTES:
1. Use only the power cord supplied with this product, or equivalent. To order a replacement
power cord, visit our website at www.telephones.att.com, or call 1 (800) 222-3111; in
Canada, call 1 (866) 288-4268.
2. Be sure to use an electrical outlet not controlled by a wall switch.
3. This power unit is intended to be correctly oriented in a vertical or floor mount position. The prongs
are not designed to hold the plug in place if it is plugged into a ceiling, under-the-table or cabinet
outlet.
4. If you receive high speed internet through your telephone line (commonly referred to as DSL), and
you are experiencing interference during telephone conversations and/or your caller ID features
are not functioning properly, install a DSL filter to the telephone line between the telephone base
and the telephone wall jack. Contact your DSL service provider for a DSL filter.
5. Plug the other end
of the telephone line
cord into a telephone
jack.
4. Plug the large end
of the larger power
adapter into an electri-
cal outlet not control-
led by a wall switch.
3. Route cords
through slots.
1. Plug one end of the telephone line cord
into the telephone jack at the bottom of
the telephone base.
2. Plug the small end of the power adapt-
er into the power jack at the bottom of
the telephone base.