Filter
Top Products
40
Answering system operation
Message counter displays
The message counter usually displays the total
number of memos and incoming messages. See
the list below for explanations of other displays in
this counter.
Message counter displays
0 No messages.
0 (flashing) The clock needs to be set (page 35).
1-95 Total number of messages and memos,
or message number currently playing.
1-95 (flashing) Total number of messages and memos.
The number flashes when there are new
(un-reviewed) messages.
If the telephone loses power, after power
is restored, the number in the message
counter will flash to indicate the clock
needs to be set.
10-99 Current remote access code while setting
(page 37).
1-99 (counting) Elapsed time while recording a memo
(page 39) or announcement up to 90
seconds (page 36).
99 (flashing) Memo recording time has exceeded the
maximum counter capacity of 99 seconds.
F (flashing) Memory is full. Messages must be
deleted before new messages can be
received.
-- System is answering a call, being
accessed remotely, or the clock is being
set.
-- (flashing) System is being setup or initialized.
On (or) OF Displayed for one second when any
answering system setting is turned on or
off.
02, 04, 06, tS Current number of rings while setting
(page 37).
1-8 Displayed for one second while telephone
base speaker volume being adjusted.
HI, LO, OF Displayed for two seconds while telephone
base ringer volume being adjusted.
Message counter