Filter
Top Products
1
INSTALLATION
Standard
electrical
outlet
Modular
telephone
jack
1 Connect the
telephone
line cord.
2 Connect the
power cord.
Before You Install
1 Choose a location for the base near an electrical
outlet and a telephone jack.
2 Install the handset battery.
This phone requires a modular telephone jack and a
standard electrical outlet (110v AC) not controlled by a wall
switch.
Table/Desk Installation
3 Charge the handset battery.
Place the handset in the base. Charge the battery for at
least 24 hours the first time. After the first charge,the
battery is typically fully charged overnight.
4 Check for dial tone.
After the batteries are charged, pick up the handset and
press P; you should hear a dial tone.
5 Set the dial mode.
If you have touch tone service, the phone is ready to
use as soon as the batteries are charged.
If you have dial pulse (rotary) service, you’ll need to
change the dial mode. When the phone is off,press
G, *, #, M to set the dial mode to dial
pulse. To return to touch tone dialing, press G,
*, *, M.
Use only the power
cord supplied with
this product. If you
need a replacement,
call 1 800 222–3111.
b) Plug battery
pack connector
into handset.
Use only AT&T
battery 3301
(SKU# 91076).
d) Replace
cover by
sliding it
up into
place.
a) Remove
battery
compartment
cover by
pressing on
the indentation
and sliding
downward.
c) Place battery
pack and wires
in compartment.