AT&T 6200 Cordless Telephone User Manual


 
Charging the Handset Battery Pack
This battery should remain charged up to six days with
the ringer turned on and up to 12 days with the ringer
off. A fully charged battery provides an average talk time
of about six hours.
The battery pack needs charging when:
A new battery is installed in the handset.
The phone beeps twice when you press P.
The phone light flashes slowly.
Place the handset in the base so the CHARGING light
turns on. The battery pack is typically fully charged in
eight hours.
You can keep the battery fully charged by returning the
handset to the base after each use.
If you repeatedly get a low battery indicator,even
after eight hours of charging, the battery should be
replaced.
Replacing the Handset Battery Pack
1 Remove the battery compartment cover on the
handset by pressing on the indentation and sliding
the cover downward.
2 Lift out the old battery pack and disconnect.
3 Align the two holes in the new battery pack’s
plug with the socket pins, and snap the plug into
place. Place the battery pack in the compartment
with the wires in the lower left corner, along the
bottom of the battery pack.
4 Replace the cover by sliding it up into place.
5 The new battery pack must be charged before
using the phone. Place the handset in the base
and allow it to charge for at least 24 hours the first
charge. The telephone might operate before that,
but for best performance, let the battery pack
charge fully.
BATTERIES
7