AT&T 6100 Cordless Telephone User Manual


 
If you hear noise or interference when using the phone:
Make sure the base antenna is fully upright.
You may be out of range. Move closer to the base.
Press and release C to change to another of the 30 channels
available. If noise is exceptionally loud,move closer to the base before
changing channels.
Household appliances plugged into the same circuit as the base can
sometimes cause interference. Try moving the appliance or the base to
another outlet.
The layout of your home or office might be limiting the operating
range. Try moving the base to another location,preferably on an
upper floor.
If the buttons don’t work, try placing the handset in the base for at
least 15 seconds.
If you hear other calls while using your phone:
Press C to change to another channel.
Disconnect the base from the modular jack and plug in a corded
telephone. If you still hear other calls, the problem is probably in your
wiring or local service. Call your local telephone service company.
If you lose a call after changing channels:
You were probably almost out of range. Move closer to the base before
changing channels. Before placing another call, set the handset in the base
for at least 15 seconds.
HEADLINE LEFT
HEADLINE L-SUB
16
IN CASE OF DIFFICULTY
6100_book_1ATT 11/25/00 12:37 PM Page 16