Filter
Top Products
Important Safety Instructions
The following list provides basic safety precautions that should always be
followed when using your telephone equipment:
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
Read and understand all instructions.
Follow all warnings and instructions marked on the product.
Unplug all telephone connections before cleaning. DO NOT use liquid
cleaners or aerosol cleaners. Use a damp cloth for cleaning.
This product should be serviced by (or taken to) a qualified repair center
when service or repair work is required.
DO NOT use this product near water, for example, in a wet basement location
DO NOT place this product on an unstable cart, stand, or table.
Never push objects of any kind into slots or openings as they may touch
dangerous voltage points or short out parts that could result in a risk of fire
or electric shock. Never spill liquid of any kind on the product.
Avoid using this telephone during an electrical storm. There may be a remote
risk of electric shock from lightning.
DO NOT use the telephone to report a gas leak in the vicinity of the leak.
The product is provided with a three-wire grounding type plug. This is a
safety feature. DO NOT defeat the safety purpose of the grounding type
plug. DO NOT staple or otherwise attach the AC power supply cord to
building surfaces.
CAUTION:
DO NOT block or cover the ventilation slots and openings. They prevent the
product from overheating. DO NOT place the product in a separate enclosure
unless proper ventilation is provided.
Additional Safety Instructions for
Installation Personnel
1.
DO NOT install telephone wiring during a lightning storm.
2.
DO NOT install telephone jacks in a wet location unless the jack is specifically
designed for wet locations.
3.
Never touch uninsulated telephone wires or terminals, unless the telephone
line has been disconnected at the network interface.
4.
Use caution when installing or modifying telephone lines.
5.
The control unit must be securely wall mounted.
CAUTION:
If any wiring from the extension jacks leaves the building premises, you must
install AT&T IROB protectors (see “Requirements for Out-of-Building
Extensions” on page 22).
CAUTION:
Use only AT&T-manufactured PARTNER modules in the PARTNER Plus
Communications System.
CAUTION:
Environmental and electrical conditions must meet the specifications as listed
on pages 21 and 22.
SAVE THESE INSTRUCTIONS
ii