Changing Remote Access Code
1 Press 9 9. The system announces
“Enter new code.”
2 Enter your new Remote Access Code
(any number between 100 and 999).
3 If a valid code is entered,the system
announces the new Remote Access
Code. If an invalid code is entered,the
system beeps five times rapidly,then
beeps twice. Repeat Steps 1
and 2.
Turn System Off
Press 0 0.
Turn System On
When the system is off, it answers after 10
rings, announces “The machine is off,” and
beeps twice.
1 Press 0 to turn the system on.
2 The system beeps twice and is ready
to answer calls and record messages.
If the system beeps five times,the
memory is full.
Memory Full
The system answers after 10 rings, then
announces “Memory is full,” and beeps
twice, you must delete messages to make
room for new ones.
1 After two-beep signal,enter the
Remote Access Code.
2 Listen to messages,and delete some or
all of them.
3 Press 0 to make sure your system is
on before you hang up.
ANSWERING SYSTEM OPERATION
FROM A REMOTE TOUCH TONE PHONE
11