Filter
Top Products
TELEPHONE OPERATION
PROBLEM SOLUTION
If you lose a call after You were probably almost out of range.
changing channels: Move closer to the base before changing
channels. Before placing another call,set
the handset in the base for at least 15
seconds.
PROBLEM SOLUTION
If you are unable If you have dial pulse (rotary) service,
to operate special follow the directions under “Temporary
telephone services Tone Dialing”in the TELEPHONE
or other equipment OPERATION section of this manual.
requiring touch tone
signals:
PROBLEM SOLUTION
If messages are • If a caller leaves a very long message,
incomplete: part of it may be lost when the system
disconnects the call after four minutes.
• If the caller pauses for more than seven
seconds,the system stops recording and
disconnects the call.
• If the system’s memory becomes full
during a message,the system stops
recording and disconnects the call.
PROBLEM SOLUTION
If you have difficulty Check the volume setting.
hearing messages:
4 4
91-5387-30-00_ATT1460_R1 2003.3.27 10:21 AM Page 44