Filter
Top Products
Logio User’s Manual, page 23
Deleting Records
There are two ways to delete entire records:
1. Navigate to the record in “view” mode and then push and hold and push .
2. Navigate to the record in “view” mode, then push to change to “edit” mode,
then delete all the characters on all three lines (see “Editing Records” section above
for information about ways to delete single characters, multiple characters, and
entire lines). After deleting all three lines of characters and with the cursor on line 3,
push or .
No matter which of these two ways you use, Logio will prompt as follows:
Push to delete the record, or push to cancel deleting. After you delete a
record, you will then be back in “view” mode and the screen will display the record
that follows the one you deleted, unless there is no following record, in which case
the screen will display the first record that precedes the one you deleted. If you
cancelled the deletion, the screen will display the record you decided not to delete.
Deleting Records