Filter
Top Products
Logio User’s Manual, page 14
Push . The screen will display:
Auto-off time is the amount of time until Logio will turn off automatically due to
inactivity (i.e., after you stop pushing buttons but have not turned it off manually).
The default setting is one minute. A longer time period means more power
consumption and higher vulnerability to intrusion and is therefore not recommended.
Note that you can add more time temporarily during any Logio session without
having to change the semi-permanent auto-off time setting (see “Auto-Off Time -
Semi-Permanent & Temporary Settings” section).
Push and if you want to change the default auto-off time setting.
Push when you are done. You can always change this setting later by pushing
the setup options button .
9. Set up contrast level
The screen will display:
Contrast level of the characters displayed on the screen is set by default to level
three and, unlike other settings, defaults back to this level every time you remove the
battery. Note that you may need to adjust the contrast level as the battery starts to
wear down over a period of use (see “Changing Setup Options” section).
Push . The screen will display:
Push and if you want to change the contrast level (14 levels are available).
Initial Setup