Filter
Top Products
- 8 -
Setting up
English
1. If the record mode is changed in step 5, the previously
recorded screens are deleted. If you do not wish to
delete the screens, do not change the record mode.
2. If you only want to change a certain item, or if you made
a mistake in the settings, you must go through the entire
sequence. Start again from "Mode selection".
3. The setting mode will end automatically after 2-1/2
minutes. If it ends during setting, start again from "Mode
selection".
• If the SET button is flashing or is on before starting, turn it
off with the following method.
• If it is flashing: Press the PLAY button. When play is
complete, press the SET button.
• If it is on: Press the SET button.
1. Mode selection:
Press the SET button for 2 seconds or more to select the
setting mode.
2. Setting the position of the date/time display:
Press the PLAY button to move upward, and the REC
button to move downward, and set with the SET button.
3. Setting the date/time:
Use the PLAY button (+) and the REC button (-) to adjust
the sequence of year _ month _ date _ hour _ minute, and
set with the SET button.
4. Setting the alarm time:
Select with the PLAY button to move upward, and the REC
button to move downward, and set with the SET button.
5. Setting record mode:
Select the number of pictures to be saved. Press PLAY
button tomove upward, and the REC button to move
downward. Set with the SET button.
6. End:
Press the TALK button to end the setting process during
steps 1 to 5. Otherwise, it will end automatically after 2-1/
2 minutes.
7
OPERATIONS
7-1
21
4
3
JB-2MEDJB-2MD
Answering a door call (Voice actuate mode)
English
1. The CALL button of the entrance station is pressed.
2. The chime tone sounds, the caller is seen on the video
monitor, and the caller's voice is heard.
3. Press the TALK button momentarily, then communicate
handsfree. The transmit LED lights when you talk, and
goes off as you listen to the caller (or hear outside sounds).
4. Press the TALK button again to end.
NOTES: 1. In step 2, the video and audio go off after approx.
45 seconds. If the TALK button is pressed within
approx. 45 sec., it connects to the caller's
entrance station.
2. In step 2, the door call-in LED on the JB-2MD
and JB-2HD lights in red if called from entrance
station 1, and in green if called from entrance
station 2.
3. If there is a lot of noise at the entrance station
and conversation is difficult, use the MANUAL
Push-to-Talk mode.
4. Communication (video) ends automatically after
approx. 1 minute. If the TALK button is pressed
within approx. 30 sec., it connects again to the
caller's entrance station.
5. If a call is received from an entrance station
while already responding to another station, a
chime tone sounds only at the master station
where communication is taking place. Quickly
finish communicating with the first calling
entrance station. Press the TALK button again
to start communication with the other calling
entrance station.
6. If it turns to dark in the evening, LEDs in the door
station light on automatically.
7-2
21
4
3
5
JB-2MEDJB-2MD