AEG C115 Telephone User Manual


  Open as PDF
of 22
 
9
tPress the OK button
to confirm.
>The third digit of the code will be blinking.
tPress the up
or down button to set the third digit of the remote access code.
tPress the OK button
to confirm the new remote access code setting.
the stop button
to return to standby mode.
8.8 TAM HD on/off setting
Two different compression rates (on and off) are provided for you to select the recording quality / total
recording time of incoming messages. With the compression rate set to on the recording quality will
be higher, but it will only save up to about 20 minutes of messages. With the compression rate set to
off the recording quality will be lower, but it will save up to about 40 minutes of messages.
tPress the menu button
.
>The display shows “OPTIONS MENU“.
tPress the up
or down button until de display shows “TAM HD: ON” (or “TAM HD: OFF”).
tPress the OK button
to confirm.
>The “ON“ (or “OFF“) will be blinking.
tPress the up
or down button to select “ON“ or “OFF“.
tPress the OK button
to confirm the TAM HD setting.
9 TELEPHONE OPERATION
9.1 Ringer volume
The ringer high / low switch located at the back of the base unit, allows you to adjust the volume of
the ringer.
High volume
Low volume
9.2 To make a call
tLift the handset or press the speakerphone button
on the base unit.
>Check for dial tone.
tDial the telephone number.
>The display shows the duration of the call in minutes and seconds.
OR Using pre-dialling:
tDial the telephone number.
>If you make a mistake you can correct it by using the delete button
to delete digits and then
adding the right ones.
tLift the handset or press the speakerphone button
on the base unit to dial out the number.
9.3 To answer a call
tWhen the phone rings, lift the handset or press the speakerphone button
on the base unit.
>The display shows the duration of the call in minutes and seconds.
9.4 To adjust the speakerphone volume
tDuring a call, adjust the volume of the speakerphone to your comfortable volume level using the
volume buttons
located on the top of the base unit.
>The display shows the volume level from 1 to 6 in the lower left corner of the LCD screen.
9.5 To end a call
>Replace the handset on the base unit cradle or press the speakerphone button
on the base unit.
 previous next