Actiontec electronic BTHS-6023-F Bluetooth Headset User Manual


 
6
Actiontec Wireless Bluetooth Headset User Manual
Turning Off
To turn the Headset off, press and hold the Large Button for three seconds. Two
short, low-pitched tones will sound, then the red light will flash. When it stops
flashing, the Headset is turned off.
Pairing the Headset
To use the Headset with a cellular phone, it must be paired with the phone. To do
this:
1. Press the Large Button for 5 seconds. Two high-pitched tones will sound, fol-
lowed by two more tones, and then the red and blue lights will flash.
2. Initiate the pairing procedure on the Bluetooth-enable cellular phone to pair
with the Headset. Make sure the cellular phone is in discovery mode.
3. Place the Headset one to three feet from the cellular phone.
4. When the cellular phone requests a passkey, enter 1234 (the default PIN of
the Headset). When pairing is successful, the red light will turn off, and the
blue light will illuminate.
If the pairing fails, the Headset will turn off automatically after two minutes.
About Pairing
Pairing is the process of associating Bluetooth devices with each other. When two
devices are paired, they establish a permanent, secure link with each other,
enabling quick access to services provided without having to enter passwords every
time either device is activated.
Paired devices remain paired even when one of the devices is not powered up, the
service connection is stopped or interrupted, or one or both of the devices are
rebooted.