Actiontec electronic BTHS-6023-F Bluetooth Headset User Manual


 
11
Troubleshooting
This section details problems that may occur when using the Headset, and solu-
tions for them.
The Red Light is flashing.What does this mean?
When only the Red light is flashing, the Headset’s rechargeable battery is run-
ning low. Plug the Headset into a wall outlet via the power adapter and recharge
the battery. Full recharge takes approximately two hours.
I charged the Headset’s battery for 20 minutes,but it still doesn’t work.
What can I do?
The Headset’s rechargeable battery must be charged for at least 40 minutes
before it can be used. It is recommended, however, that the battery be charged
for the full two hours.
I plugged the Headset into an electrical socket, but it doesn’t appear to be
recharging.What’s going on?
If the Headset hasn’t been used for a long time, or the battery is nearly empty, it
may take a few minutes for the Red Light to flash and indicate that it is recharging.
I am getting no sound between the Headset and the device it’s connnected
to.What should I do?
Check the following:
•Make sure the Headset and the device have been paired.
•Make sure the Headset is turned on.
•Make sure the Headset and the device are withn working range of
each other.
•Ifconnecting to a cellular phone, make sure it has good signal strength.
•Some cellular phones support only one Bluetooth headset at a time.
Disconnection can occur if more than one Headset is being used.
3