● Administrator Authorization
1. Press the CAMERA (ENTER) button while [SEtUP] is
displayed. The [- - - - -] prompt appears.
2. Enter a password using the numeric buttons, then press
the CAMERA (ENTER) button.
The default setting is [12345].
3. If the password entered is valid, [SPEED] appears. If
password entry failed, the menu returns to [SEtUP].
● Baud Rate
In this menu, the communication speed (bps: bits per sec-
ond) is selected. The communication speed should match
that of the WJ-SX850.
1. Display [SPEED], and press the CAMERA (ENTER)
button twice.
2. Select a parameter entering a bracket-enclosed num-
ber, e.g., (3), moving the joystick.
The default setting is 9 600 bps.
(1) 2 400: 2 400 bps
(2) 4 800: 4 800 bps
(3) 9 600: 9 600 bps
(4) 19 200: 19 200 bps
Note: Selecting a slower rate (e.g., 2 400 bps) will
delay the response time (e.g., the time until an acti-
vated alarm is reset).
3. Press the CAMERA (ENTER) button to validate the
selection.
4. Press the CLEAR(ESC) button to return to the [SPEED]
menu.
● Parity
In this menu, the parity check mode is selected.
1. Display [PrtY] and press the CAMERA (ENTER) button
twice.
2. Select a parameter with the joystick.
The default setting is None.
n: None
E: Even parity
3. Press the CAMERA (ENTER) button to validate the
selection.
4. Press the CLEAR(ESC) button to return to the [SPEED]
menu.
Note: The baud rate and parity check mode of the WJ-
SX850 and the controller must be the same, otherwise
data communications will not function.
