32
Automatic Editing (deck-to-deck)
Previewing
1
After the edit points have been registered, press
the PREVIEW button.
Regular preview is now conducted.
<Notes>
• If the edit IN point has not been registered, the
position where the PREVIEW button was
pressed is registered as the edit IN point.
• To stop the preview at any time, press the
STOP button.
• When the PREVIEW button is pressed again
after the IN point during the course of a preview,
the preview will start again from the beginning.
• When the edit OUT point is reached, the tape is
postrolled, after which it stops automatically.
1
Press the AUTO EDIT button.
Automatic editing is now executed.
• To suspend editing at any time, press the STOP
button.
• When the edit OUT point is reached, the tape is
postrolled, after which it stops.
Postrolling
In the case of assemble editing, editing continues
for about 2 seconds after the edit OUT point is
passed, and the tape is then returned to the OUT
point, after which it stops.
In the case of insert editing, the PLAY mode is
established after the edit OUT point has been
passed, and the tape is then returned to the OUT
point, after which it stops.
Retry function
Even when the STOP button has been pressed to
suspend editing, editing can be repeated from the
beginning simply by pressing the AUTO EDIT
button again.
Auto tag function
If, upon completion of editing, when the AUTO
EDIT button is pressed although the next edit point
has not yet been registered, the previous edit OUT
point is registered as the IN point, and editing is
executed.
To release the auto tag mode, press one of the
transport system buttons (such as the PLAY
button).
<Note>
The registered points are automatically cleared
after editing has been executed. However, the
previous edit points can be recalled by pressing
the TRIM
i
(or TRIM
j
) button and SET button at
the same time.
Automatic editing
