Switch settings and adjustments
When using this VTR as the recorder
Automatic Editing (deck-to-deck)
1
Using the REMOTE button, set the player to
REMOTE and the recorder to LOCAL (ensure that
the REMOTE LED is not lighted).
2
Select the editing mode (ASSEM or INSERT).
3
Register the edit points of the recorder and player.
4
Check and modify, if necessary, the edit points.
5
Preview the material before editing it.
6
Proceed with the editing.
7
Review the edited results.
“Editing” refers to the work involved in using pre-
recorded tapes to bring different contents together or
delete unnecessary parts and bring together only the
necessary parts.
The basic editing steps are as follows.
Set the POWER
switch to ON.
Adjust the recording
levels.
Switch the time counter display to TC
or CTL.
Set the VTR to the LOCAL status (which is
indicated when the REMOTE LED is OFF).
When using this VTR as the player
Set the POWER
switch to ON.
Adjust the playback
levels.
Switch the time counter display to TC
or CTL.
Press the 9P button for 2 or more seconds
to set the VTR to the REMOTE status which
is indicated when the REMOTE LED is ON).
