11
nn – telephone number up to 16 digits to be stored. Refer to the table for other
choices.
The number stored in parameter 2 is the number for the second group or the
number for Night mode
Note: The switchover to Day/Night mode remains set in the unit even after line
disconnection.
5.2 Relay
Parameter Value Description Default Exam.1 Exam.2
31 r m
Relay mode
1 1 2
m – relay mode [ 1-2]
m=1 relay mode – relay will close on command or password for ss period (used for electrical locks, gate
opening, etc.)
m=2 button mode – (activated by button press e.g. external bell).
Parameter Value Description Default Exam.1 Exam.2
32 r hhhhhh
External access code in
DAY + NIGHT mode
- 1212 1324
33 r hhhhhh
External access code in
DAY mode
- 2211 2211
34 r hhhhhh
External access code in
NIGHT mode
- 1122 1122
hhhhhh – password for relay closing from buttons [2 to 6 digits]
The 3 passwords are controlled by Day/Night; the combination is entered using the unit buttons. It is
influenced by the setting of Relay mode and Day/Night switchover. When set to 2-group mode the unit is
permanently in DAY mode.
Follow these rules when choosing password combination:
Select passwords carefully, to prevent their discovery from wear on buttons caused by frequent
use.
Select the first password button from infrequently-used buttons for direct dialling (-extends choice
time)(-not valid for keyboard).
Note: The switchover to Day/Night mode remains set in unit even after line disconnection.
Parameter Value Description Default Exam.1 Exam.2
35 aa
Internal access code
55 55 55
aa – command from phone to relay closing [2 digits]
It is recommended to set the same command for Internal Access Code and End Call (parameter 43)
aa=bb.
Parametr Value Description Default Exam.1 Exam.2
36 ss
Relay closing time
05 02 05
ss – duration of relay closing [2 digits 01-99]
parameter choice
0 - 9 0 - 9
# #
∗ ∗∗
Recall
∗ #
Pause
∗ 0
